Vaillant ecoTEC plus SERIES - 11 Adapting the Boiler to the Heating Installation; Diagnosis Codes - Overview

Adapting the boiler to the heating installation
Installation and maintenance instructions ecoTEC plus 0020116700_01 49
11
11 Adapting the boiler to the heating
installation
The installation assistant is started when the boiler is
switched on for the first time (¬section10.2).
If you have already filled the heating installation and termi-
nated the installation assistant, but wish to set the most
important system parameters again, you can also call up
the "Appliance configuration" menu point.
Menu ¬ Installer level ¬ Appliance configuration
All of the settings for more complex systems can be found
in the diagnosis menu.
Menu ¬ Installer level ¬ Diagnosis menu
11.1 Diagnosis codes – Overview
Menu ¬ Installer level ¬ Diagnosis menu
With the use of the parameters that are marked as adjusta-
ble in ¬table11.1, you can adapt the boiler to the heating
installation and the needs of the customer:
i
You can enter your settings in the last column
after setting the system-specific parameters.
> Press the minus button
or the plus button
to switch between the displayed diagnosis
codes.
With modifiable parameters:
> Press the right selector button
("Selection")
to select the parameter to make a change.
> Press the minus button
or the plus button
to change the current setting.
> Press the right selector button
("Ok") to con-
firm the change.
The change is saved.