Chapter 4 _______________________________________________________________ Installation
VAISALA _______________________________________________________________________ 25
2. Make sure that the threads on the mounting point are of the correct
type, and fasten the transmitter to the measurement point. When
installing a transmitter with ISO or UNF thread, use the provided
sealing ring to achieve a tight installation. Check that the sealing
ring remains centered.
1109-032
Figure 9 Installing the Transmitter
1109-033
Figure 10 Tightening with a Wrench
3. Tighten the connection by turning with a wrench (max. 50 Nm).
CAUTION
Only tighten the transmitter from the 30 mm nut. Do NOT apply force to
other points in the transmitter body.
4. Continue with the wiring of the transmitter. See section Wiring on
page 26.
To Next Page
Loading...
