Vaisala DPT146 - Closing the Connection to a Transmitter in POLL Mode; Show Transmitter Uptime; Reset Transmitter; Restore Factory Settings

Chapter 5 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 53
Closing the Connection to a Transmitter
in POLL Mode
The CLOSE command closes the connection to a transmitter.
CLOSE<cr>
Example:
close
line closed
Show Transmitter Uptime
Use the TIME command to show how long the transmitter has been
operating since it was last reset or powered up.
TIME<cr>
Example:
time
Time : 03:14:10
Reset Transmitter
Use the RESET command to reset the transmitter.
RESET<cr>
When the RESET command is given, the transmitter will restart as if it
had just been powered on. All transmitter settings are retained. The serial
line mode of the transmitter will be set to the mode that was set using the
SMODE command.
Restore Factory Settings
Use the FRESTORE command to restore the factory settings to the
transmitter. All user settings will be lost.
FRESTORE<cr>