Vaisala DPT146 - Show Firmware Version; Show Serial Number; Configuring Analog Output; Set Analog Output Mode

USER'S GUIDE____________________________________________________________________
42 __________________________________________________________________ M211372EN-B
Show Firmware Version
VERS<cr>
Example:
vers
DPT146 1.0.23
Show Serial Number
SNUM<cr>
Example:
snum
Serial number : F4040027
Configuring Analog Output
Set Analog Output Mode
Use the AMODE command to change the analog output mode:
AMODE [c1 c2]<cr>
where
c1 = Channel 1 analog output mode. Available options are:
1 = 0 ... 20 mA
2 = 4 ... 20 mA
4 = 0 ... 5 V
5 = 0 ... 10 V
c2 = Channel 2 analog output mode. Available options are the
same as for channel 1.
Example:
amode 2 5
Ch1 output : 4 ... 20 mA
Ch2 output : 0 ... 10 V