Vaisala DPT146 - Show Currently Active Errors; Show Command List

Chapter 5 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 41
Show Currently Active Errors
Use the ERRS command to display the currently active transmitter error
messages. Possible errors and their causes are listed in Table 11 on page
62.
ERRS<cr>
Example:
errs
No errors
Example (one active error, caused by physical damage to the sensor):
errs
T MEAS error
Show Command List
Use the HELP command to show a list serial commands:
HELP<cr>
Example:
help
ADDR
AERR
AMODE
AOVER
ASEL
ATEST
CLOSE
ERRS
FORM
FRESTORE
INTV
OPEN
R
RESET
SDELAY
SEND
SERI
SMODE
SNUM
TIME
UNIT
VERS