Chapter 5 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 39
List of Serial Commands
All commands can be issued either in uppercase or lowercase. In the
command examples, the keyboard input by the user is in bold type.
The notation <cr> refers to pressing the carriage return (Enter) key on
your computer keyboard. Enter a <cr> to clear the command buffer
before starting to enter commands.
Table 6 List of Serial Commands
Command Description
? Show device information
?? Show device information (overrides poll mode)
ADDR [0 … 255] Show or set transmitter address
AERR Set analog output error level
AMODE Set analog output mode
AOVER [ON/OFF] Allow analog outputs to exceed their range 10%
ASEL Set analog output parameters and scaling
ATEST Test analog outputs
CLOSE Close the temporary connection and return the
device to POLL mode
ERRS Display the currently active errors
FORM [modifier string] Set output format
FRESTORE Restore factory settings
HELP Show list of currently available serial commands
INTV [0 ... 255 S/MIN/H] Set the continuous output interval (for RUN mode
and R command)
OPEN [0 … 255] Open a line to transmitter at defined address
R Start the continuous outputting
RESET Reset the transmitter
S Stop the continuous outputting
SDELAY [0 … 255] Set response sending delay
SEND [0 … 255] Output readings once (specify address for
transmitters in POLL mode)
SERI [baud p d s] Show or set the serial interface settings
SMODE [mode] Show or set startup serial mode:
RUN, STOP, or POLL
SNUM Display transmitter serial number
TIME Show transmitter uptime
UNIT [m/n] Select metric or non-metric units
VERS Show transmitter firmware version
To Next Page
Loading...
