Vaisala DPT146 - Set Serial Line Response Time; Other Commands; Opening the Transmitter in POLL Mode

USER'S GUIDE____________________________________________________________________
52 __________________________________________________________________ M211372EN-B
Set Serial Line Response Time
With the SDELAY command you can set delay (response time) of the
serial line, or view the currently set delay value. Increasing the value by
one increases the delay by 4 milliseconds. For example, the default value
is 10 which equals a ~40 ms answer delay.
SDELAY [delay]<cr>
where
delay = Serial line delay, range 0 … 255.
Example:
sdelay 20
Serial delay : 20
Other Commands
Opening the Transmitter in POLL Mode
Use the OPEN command to connect to a transmitter that is in POLL
mode.
OPEN [address]<cr>
where
address = Transmitter address, range 0 ... 255.
Example (target transmitter in POLL mode, with address 5):
open 5
DPT146 5 line opened for operator commands