This procedure assumes the Indigo200 transmitter is powered on and the probe is
connected to it. Refer to the user guide of your Indigo200 transmitter model for
instructions on connecting probes. The user guide also provides more detailed
instructions for operating and troubleshooting the wireless connection.
1. Connect to the wireless configuration interface of the Indigo200 transmitter:
a. Press the wireless connection activation button on the bottom of the transmitter.
b. Open the wireless connection menu in your mobile device or computer and select
Indigo_ID[xx] (transmitter-specific SSID) from the list of available connections.
c. If the wireless configuration interface does not launch automatically on your device,
start your browser application manually and navigate to address 192.168.1.1.
d. Log in to the interface:
• User name: Admin
• Password: 12345 (default)
Stay close to the transmitter for a strong wireless signal and the possibility to
read on-screen messages from the transmitter's display (display models
only). Starting with Indigo200 firmware version 1.4.0, messages from the
probe are also shown through the wireless configuration interface.
Chapter 7 – Maintenance
57
To Next Page
Loading...
