3.3 Mounting with Wall Mounting Set
• Wall Mounting Set (Vaisala item OPTMSET1)
• Installation beam (2 pcs)
• Cradle for Power Supply Unit
• Screws and washers
• M8 anchors or bolts (suitable for wall material)
• 6-mm Allen key
Use enough anchors or bolts to fill local safety factor requirements.
Also account for possible vibrations and other sources of additional mechanical
stress.
Use anchors or bolts that are suitable for the wall material at the installation
location. Note that they are not included with the Wall Mounting Set.
CAUTION!
1. Attach one of the installation beams to the mounting location, at a height where you want
the top of the OPT100 cabinet to be. Make sure it is securely attached from at least two
points, and can bear the full weight of the DGA monitor.
2. Attach the second installation beam at the height of the second set of mounting holes.
3. Attach screws with washers to the top mounting holes of each pair on the sides of the
OPT100 cabinet (four screws in total). Tighten them enough to safely bear the weight of
the cabinet but not all the way in. The second hole of each set must remain free at this
point.
4. With two people lifting, lift the OPT100 cabinet up and hang it from installation beams by
the screws. If the lower installation beam is not at the correct height, re-attach it at the
correct height before attempting this step again.
5. Tighten the four screws to secure the cabinet in place.
OPT100 Installation Guide M211857EN-R
26
To Next Page
Loading...