Vaisala Optimus OPT100 - Changing Administrator Password; Figure 29 Changing Administrator Password

2. Open a web browser, and enter the IP address of the DGA monitor in the address bar:
• If you connect locally through the ETH1 port, use the following IP address:
192.168.28.2
• If you connect through the network meant for SCADA integration, use the IP address
that has been assigned to the DGA monitor.
3. You will get a warning that your connection is not secure. This is expected and happens
when connecting with a new device. The user interface of the DGA monitor is secured
with a self-signed certificate by default. Continue despite the warning. HTTPS trac is
always encrypted even if the certificate is not trusted.
4. Select Admin as the user name.
5. Enter the unique administration password for this DGA monitor. The password is included
in the delivery documentation.
6. Select Log in.
5.3
Changing administrator password
If you forget your administrator password, contact Vaisala Support
to reset it for you.
CAUTION!
Figure 29 Changing administrator password
OPT100 Installation Guide M211857EN-R
66