Do not make a fixed Ethernet connection directly to DMU or any
other ports not mentioned in these instructions. Bypassing protection
components and connecting directly to other ports can damage components.
CAUTION!
1. Assemble the protection shell over the RJ45 connector on your Ethernet cable. Assemble
according to Code A: see instructions on top of the bag that contains the parts.
You must use the protection shell to maintain the ingress
protection rating of the cabinet.
CAUTION!
Figure 23 RJ45 connector inside the protection shell
2. Open the plug marked Ethernet under the DGA monitor.
3. Plug in the Ethernet cable.
Chapter 4 – Electrical installation
53
To Next Page
Loading...