Vaisala Optimus OPT100 - Configuring User Interface Security; Figure 31 Network Security Settings Page

3. If you enabled the external Ethernet connection, select how its IP address is assigned:
DHCP for automatic assignment, or Static IP address to enter the values manually.
4. If you selected Static IP address, enter the following values:
• IP address
• Subnet mask
• Default gateway
IP addresses in 192.168.28.0/24 cannot be used for the external network
connection (ETH0) since they are reserved for the service port (ETH1).
5. Select Apply to save your changes.
5.5 Configuring user interface security
Figure 31 Network security settings page
Configure HTTPS encryption for the user interface connection. By default, DGA monitor only
allows encrypted connections to the user interface (HTTPS) using a self-signed certificate. Any
connections that request unencrypted communication (HTTP) are redirected to the encrypted
interface (HTTPS).
OPT100 Installation Guide M211857EN-R
68