Vaisala Optimus OPT100 - Using Protocol Test Mode; Figure 38 Protocol Test Mode Enabled

1. In the user interface, select Settings > Network > IEC 61850.
2. Select if the IEC 61850 protocol should be Enabled or Disabled.
3. Select Apply to save your changes.
Download the following supporting documents from this page:
• IED Capability Description (ICD) file
• Protocol Implementation Conformance Statement (PICS)
• Model Implementation Conformance Statement (MICS)
5.13 Using protocol test mode
Figure 38 Protocol test mode enabled
1. In the user interface, select Settings > Network > Protocol Test Mode.
2. Check the status of the protocols listed under Protocols. Make sure the protocols you
want are enabled. If they are not, you must enable and configure them first before
continuing this procedure.
Chapter 5 – Commissioning
79