135
14.6 REPLACING THE MIXER SCRAPERS AND SLIDERS
At each change of scrapers is also necessary to replace the sliders!
At any change you must change all scrapers and all sliders (never only one or
two,...).
The mixer scrapers and sliders replacing process:
make sure that the preparation and making control panels are in the
STOP position;
make sure that the production cylinder is empty;
turn off the SAFETY SWITCH and the MAIN SWITCH;
open the door;
slowly and carefully with both hands pull the mixer out of the cylinder;
exercise great care to prevent accidental dropping and consequent
damaging of the mixer:
place the mixer on solid surface and remove each slider from the mixer
individually;
To Next Page
Loading...
