45
Logs and rocks
Each log has pegs to help you locate them on the
platform. Install the logs as shown below.
1. Place the rear log in the center of the fi rebox at the
rear. NOTE: There are two holes for the left peg of
this log depending which type of gas is used for the
appliance.
NG fi re: Place the log’s left peg in the front hole for
natural gas (NG) fi re.
LPG fi re: Place the log’s left peg in the rear hole for
propane gas (LPG) fi res.
2. Place the rear left log as indicated.
3. Place the front left log as indicated.
NG
LPG
4. Place the right rear log as indicated. Pivot tail end to
just cover small hole located in platform.
5. Place right cross log as indicated. Pivot other end
to locate on to recess of right rear log as indicated,
ensure fi rmly located.
Installation
QUALIFIED
INSTALLER
To Next Page
Loading...
