EasyManuals Logo
Home>Valor>Fireplace Accessories>L2 SERIES

Valor L2 SERIES User Manual

Default Icon
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the replace cool rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the battery box
or the handset! This could cause a short circuit.
Battery box in carrier
Receiver
Window
The battery box is located on the bottom of the
appliance behind the front panel.
Remove plinthRemove side doors
Long Beach Driftwood Kit Correct Flame Picture
Rock & Shale Kit Correct Flame Picture
Murano Glass Fire Correct Flame Picture
Pilot Flame can
be seen left of
the re bed
Pilot Flame can
be seen left of
the re bed
Pilot Flame can be seen
between the front and
rear left logs
Pilot Flame
Thermocouple Probe
must be in Flame
!
Owners Information
6. Reinstall the barrier screen on the trim.
a) 1755 1” trim: Insert the screen’s top tabs in the
slots in the convection baf e then rest the screen
bottom tabs on the edge of the opening in the
plinth to lock it in position.
b) 1750 5.1/4” and 1770 trims: Hook the bottom
of the screen to the bottom edge of the trim’s
front plate, then, with the top levers up, push the
screen against the replace. Rotate the levers
down to hook them up to the trim and slide them
inwards to secure them.
7. Verify that the screen is properly hooked to the trim
and secure.
Checking Pilot and Burner Flames
A periodic check of the pilot and burner ames should
be made. Check after the re has been on for at least
30 minutes. The pilot ame must cover the tip of the
thermocouple probe. The main burner ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Replacing Batteries
Low batteries signal: see page 15.
BEFORE changing the batteries, disconnect the
battery box from the receiver.
The appliance uses four 1.5 V AA alkaline batteries
for its battery box and one 9 V alkaline battery for its
handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off-
season will extend the battery life.
To replace the batteries in the battery box:
The battery box is located in a sliding carrier to the right
hand side of the appliance behind the front panel.
1. Remove the barrier screen, side doors and plinth.
OWNER’S
INFORMATION

Other manuals for Valor L2 SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Valor L2 SERIES and is the answer not in the manual?

Valor L2 SERIES Specifications

General IconGeneral
BrandValor
ModelL2 SERIES
CategoryFireplace Accessories
LanguageEnglish

Related product manuals