48
Install Rocks & Shale Set 1714RSS
Material required
• Black steel platform (supplied with appliance)
• Small container to distribute shale (not supplied)
• Rock & Shale Set, which contains:
◊ 1/2lb-bag of 3/4” grey shale
◊ 1/2lb-bag of 3/4” black shale
◊ 5 twigs
◊ 34 rocks
Installation
Platform
Carefully unpack the kit.
Install the steel platform around the burner as
indicated. The openings in the platform should be
underneath. Push the platform as far back as possible
to maximize the air gap behind the burner.
Rocks, Shale & Twigs
1. Place three rocks on the burner, one at each end
and one in the middle as indicated. The rocks
should not sit on top of the burner ports but can
overhang slightly.
Note: Although these rocks can be installed after
the shale is distributed, it is recommended to install
them fi rst to obtain a better fl ame display.
Installation
Installed platform
Gap behind burner
No gap in front of burner
Top view—platform
IMPORTANT: Use only the ceramic rocks, twigs and
shale provided with your Valor fi replace The use of
any other types of rocks, twigs or shale may void your
fi replace warranty.
WARNING
CHOKING HAZARD! Ensure that the fi replace
area is clear of shale pieces as these could be
ingested by small children. Vacuum area after
installation.
!
QUALIFIED
INSTALLER
To Next Page
Loading...
