USER MANUAL
5.1.8.4 PD (Pedestrian Detection)
Pedestrian Detection function detects the moving people in a pre-defined region, and a series of
actions can be taken when the alarm is triggered.
Channel
: to select the channel you want to configure
Switch
: to enable or disable the PD function
Buzzer
: to disable or to active the buzzer to emit an alarm tone in 10, 20, 40 or 60 seconds when
the detection is triggered
Level
: Small, Middle & Big. Small level is recommended to detect objects in long
distance. Big level is recommended to detect objects in short distance.
Scene
: Scene setting includes Indoor and Outdoor. Please choose the scene to
match with the place your camera installed.
Post Recording
: You can set how long after an event occurs that the DVR will continue to record.
Latch Time
: To configure the external alarm time when the detection is triggered.
Alarm Out
: If your DVR support to connect to external alarm device, you can set to emit an alarm
tone.
Show Message:
A letter “S” will be displayed on the screen when the intelligent detection is
triggered.
Send Email:
If an alarm is triggered, an Email will be sent to your preset email account.
Full Screen:
When the detection is triggered, the channel will be enlarged into full screen.
Record Channel:
to select the channel(s) you want to record when a detection is triggered.
Area:
Click [
Setup
] to draw a virtual region in the camera picture.
37
To Next Page
Loading...