VAMP 50 User Manual

Technical description 6 Communication 6.1 Communication ports
VM50.EN004 VAMP 24h support phone +358 (0)20 753 3264
169
Parameters
Parameter Value Unit Description Note
Protocol
None
SpaBus
ProfibusDP
ModbusSla
ModbusTCPs
IEC-103
ExternalIO
DNP3
Protocol selection for the
rear panel local port.
Command line interface
for VAMPSET
SPA-bus (slave)
Profibus DB (slave)
Modbus RTU slave
Modbus TCP slave
IEC-60870-5-103 (slave)
Modbus RTU master for
external I/O-modules
DNP 3.0
Set
Msg#
0 ... 2
32
1
Message counter since
the device has restarted
or since last clearing
Clr
Errors
0 ... 2
16
1
Protocol errors since the
device has restarted or
since last clearing
Clr
Tout
0 ... 2
16
1
Timeout errors since the
device has restarted or
since last clearing
Clr
speed/DPS
Default =
38400/8N1 for
VAMPSET
Display of actual
communication
parameters.
speed = bit/s
D = number of data bits
P = parity: none, even,
odd
S = number of stop bits
1)
VAMPSET communication (Direct or SPA-bus embedded command line
interface)
Tx bytes/size
Unsent bytes in
transmitter buffer/size of
the buffer
Msg#
0 ... 2
32
1
Message counter since
the device has restarted
or since last clearing
Clr
Errors
0 ... 2
16
1
Errors since the device
has restarted or since last
clearing
Clr
Tout
0 ... 2
16
1
Timeout errors since the
device has restarted or
since last clearing
Clr
Set = An editable parameter (password needed)
Clr = Clearing to zero is possible
1) The communication parameters are set in the protocol specific menus. For
the local port command line interface the parameters are set in
configuration menu.

VAMP 50 Specifications

General

Brand	VAMP
Model	50
Category	Relays
Language	English