VARI❋LITE® - VL2402™ WASH LUMINAIRE USER’S MANUAL
68 17-Sept-01 02.9671.0001 C
To edit or modify a cue:
1. Recall cue to be changed from PCue.
2. Change luminaire data to desired levels using Man (Manual Command)
functions.
3. Press [Up] / [Down] arrows until Cue appears. Press [Enter].
4. Press [Up] / [Down] arrows until Mod appears. Press [Enter]. The number
displayed is the same as the selected cue.
5. Press [Enter] and changes will be saved.
To play cues as a sequence:
1. Press [Menu].
2. Press [Up] / [Down] arrows until Cue appears. Press [Enter].
3. Press [Up] / [Down] arrows until PSEQ appears. Press [Enter] and the
sequence will play. The active cue will be shown in the display. [Enter] to
start, [Menu] to stop.
To change the follow time in a sequence:
The follow time is stored for each cue individually.
1. Select cue to be changed from PCue.
2. Go to Mod to modify active cue and press [Enter] to save the change.
3. Set FLTM (Follow Time) to desired value (refer to “Set follow time between
cues:” on page 67).
To delete a sequence and all cues:
1. Press [Menu].
2. Press [Up] / [Down] arrows until Cue appears. Press [Enter].
3. Press [Up] / [Down] arrows until DSEQ appears. Press [Enter].
4. OK? prompt will appear. Press [Enter] to delete stored sequence.
To Next Page
Loading...
