Vector Revolution 180 - Page 6

_______________________________________
5
9.3.4 Advanced Controls: Feed 9- 63
9.3.5 Advanced Controls: 360 Panel 9- 65
9.3.1 Advanced Controls: Panel Shapes 9- 66
9.4 Cycle Functions 9 – 67
9.4.1 Standard Conditions 9 - 67
9.4.2 Convex (external) Corner 9 - 67
9.4.3 Concave (internal) Corner 9 - 72
9.4.3.1 Aggregate pushed back by Bump Bar 9 - 73
9.4.3.2 Aggregate retracted by Bump Bar 9 - 74
9.4.3.3 Aggregate retracted by Bump Switch 9 – 75
9.4.4 Special Sequences 9 - 79
9.4.4.1 Setting trigger points 9 - 80
9.4.4.2 Setting up special sequences 9 - 81
9.5 Functions Page 9 - 83
9.6 Save/load settings 9 - 85
9.7 Alarms 9 - 87
10 Care and maintenance
10.1 General instructions 10 - 1
10.2 Maintenance chart 10 - 2
11 Troubleshooting and remedies
11.1 Simple fault schedule 11 – 1
11.2 List of alarms 11 – 3
11.3 Start Prevent alarms 11 - 4
12 Notes 12 - 1