Veeder-Root EMR4 User Manual

C&C Mode C&C Mode Setup Categories
51
Figure 49. Delivery and Shift Report Formatting Examples
Supose you want to modify the example
Delivery Ticket format as follows:
• Switch TANK ID and METER ID labels
Procedure
Since moving is copy/replace, you have
to save the destination line first.
Think of the lines following the END
OF REPORT line (line 45 in the default
example) to line 75 (last possible line)
as a scratch pad in which you can 'save'
labels before you move them around.
1. Copy METER ID from line 13 to Scratch
pad line 45.
2. Copy TANK ID line 14 to line 13.
3. Copy METER ID line 45 to line 14.
The change appears as shown below:
Line 1
Line 2
Line 3
Line 4
Line 5
Line 6
Line 7
Line 8
Line 9
Line 10
Line 11
Line 12
Line 13
Line 14
Line 15
Line 16
Line 17
Line 18
Line 19
Line 20
Line 21
Line 22
Line 23
Line 24
Line 25
Line 26
Line 27
Line 28
Line 29
Line 30
Line 31
Line 32
Line 33
Line 34
Line 35
Line 36
Line 37
Line 38
Line 39
Line 40
Line 41
Line 42
Line 43
Line 44
Line 45
Line 75
END OF REPORT
Veeder-Root Co.
EMR-3
(blank)
(blank)
(blank)
START
FINISH
(blank)
TICKET NUMBER
(blank)
PROD DSCRPT 1
METER ID
TANK ID
CUSTOM FIELD 1
CUSTOM FIELD 2
CUSTOM FIELD 3
CUSTOM FIELD 4
CUSTOM FIELD 5
CUSTOM FIELD 6
CUSTOM FIELD 7
TOTALIZER START
TOTALIZER END
VOLUME GAL START
GROSS VOLUME FINISH
NET VOLUME FINISH
AVG FLOW RATE (GPM)
TEMP THIS DELIVERY
VOLUME CORRECTED TO
COEFFICIENT OF EXPANSION
PRICE/GALLON
SUBTOTAL
% TAX T/D 1
FINAL PRICE/GALLON
TOTAL NON-TAX LINES
TAX THIS DELIVERY
GRAND TOTAL
CRC ERROR
(blank)
You can count on us!
(blank)
(blank)
(blank)
END OF REPORT
Delivery Ticket (Example)
Example 1 - Switching 2 lines
IMPORTANT! If you want to insert a line you
will have to copy each line below the insert
point to the scratch pad, then copy them back
into the Ticket/Report format below the inserted
line, one by one.
Before beginning an insert, on a clean sheet
of paper, list each line number and label you
want in the finished report. After you copy
all of the necessary lines from the default
report into the scratch pad, you can easily use
your h
andwritten report as a guide when copying
each line back into the final report.
Example 3 - Inserting a line
Prints only if TC enabled
Prints only if TC not enabled
PROD DSCRPT 1
TANK ID
METER ID
TICKET NUMBER
Line 12
Line 13
Line 14
Line 15
Yo u do not have to go back and write
over line 45 in the scratch pad since all
lines after the END OF REPORT line
(line 44) are ignored.
Scratch Pad

Veeder-Root EMR4 Specifications

General

Brand	Veeder-Root
Model	EMR4
Category	Measuring Instruments
Language	English