8
HPS50 PersonalScope
TM
Safety & Warnings
⇒ The PersonalScope is ideally suited for measure-
ments of category II installations with pollution
degree II and using a maximum of 600V, in ac-
cordance with the IEC1010-1 norm.
⇒ Consequently, all measurements should be avoi-
ded in case of polluted or very humid air. One
should also refrain from measuring conductors
or installations that use voltages that exceed
600Vrms above ground level. CAT II indicates
conformity for measurements of domestic instal-
lations.
⇒ The maximum input voltage for the connections
of the unit stands at 100Vp (AC+DC)
⇒ Do NOT open the enclosure while performing
measurements.
⇒ Remove all test leads before opening the enclo-
sure in order to avoid electrical shock.
⇒ Use a measuring probe with an insulated
connector when measuring voltages exceeding
30V. (PROBE60S).
Symbols displayed on the unit - Symbolen op het toestel -
Symboles sur l'appareil - Symbole auf dem Gerät
Important safety information, see user manual.
Belangrijke veiligheidsinformatie, zie gebruiksaanwijzing.
Information importante relative à la sécurité, voir mode d'emploi
Wichtige Sicherheitsinformationen, siehe Gebrauchsanleitung.
!
SAFETY & WARNINGS
To Next Page
Loading...
Need help?
General
