Maintenance
To ensure your ProStart's enclosure remains watertight and the electronics are not destroyed by
corrosion, please take the following precautions:
• Always replace the USB port cap securely before exposing the ProStart to the marine
environment.
• Dry case with a towel before opening the USB port cap.
• Wipe away sand or debris on the gasket before closing the USB port cap.
• Once the cap is open wipe away any loose water droplets.
• If you ever see signs that water is leaking inside the enclosure, please contact Velocitek Support
immediately at (866)-498-6737 or support@velocitek.com to arrange to have your device
repaired and made watertight again.
To Next Page
Loading...
