Veloretti Ace Two - Battery and charger

28
EN
4. Get to Know Your Bike
Installing the baery
Removing the baery
The Electric Two is geing its power from our in-house developed rechargeable Li-ion Baery. This chapter features instructions and
operational guidelines.
4.06 Baery and charger
Step 1 : Place in holder
Step 1 : Unlock baery lock Step 2 : Turn baery lever Step 3 : Remove the baery
Step 2 : Click baery in
Press once to increase RPM level.
Insert the lower part of the baery precisely into the baery holder
(lower baery bracket).
Make sure the handlebar is straight. Next,
take your baery key and insert the key into
the baery lock. Turn the key in a clockwise
direction about 90 degrees.
Pull the release lever aached to the
baery. The baery will come loose from
the holder. Hold the baery tightly as it
is heavy.
Remove the baery from the baery
holder.
Push the upper end of the baery into the holder. As soon as
the baery is correctly placed, there will be an audible click.
Additional locking is not needed.
1 2
Click
Your baery needs to be clicked in completely before riding the bike and should be aligned with the frame.
Be careful pulling out the baery, to not scratch the frame.
For correct insertion, the baery must be connected, ensuring all pins are correctly connected to the baery holder. When push-
ing the baery into position. Make sure that the baery has clicked into the locking mechanism before you set o.