29
EN
4. Get to Know Your Bike
Baery general instructions
Baery safety instructions
Baery guidelines — electrical component
Your Electric can be equipped with dierent baery types (Depending on the manufacturer’s conguration)
It is possible for the baery to cause a re, explosion or hazard if the baery is connected to an incompatible system. Do not open,
disassemble or pierce the baery, as this can lead to short circuits, leaks, res or explosions. If the baery falls to the ground or
is exposed to a blow or similar event, do not continue to use the baery, take it to your retailer to examine. Use only the original
charger supplied with the baery, otherwise, it can lead to an explosion or permanent damage. Used baeries must be disposed
of at a suitable disposal point.
Baery label : The content on the label is important information about this product. Before use, read the information. Please do not
remove the information from the baery.
Please only use the original charger to charge the baery. The baery is not fully charged when it is delivered. Please charge the
baery completely before its rst use and before storage.
It is recommended to charge the baery aer use. Deep discharge is harmful to the baery. Never fully discharge the baery. If
the baery remains uncharged for an extended period, this will damage the capacity of the baery. For storage, the
recommended capacity of the baery should be between 60-80%.
The baery should always be kept out of reach of children. The use of the charger or the baery is not suitable for children
Do not touch a leaking baery. Leaking electrolytes can seep into the skin and cause discomfort. If baery acid encounters the
eyes, do not rub it! Immediately wash your eyes carefully with clean water and consult a doctor or a hospital.
A faulty baery can lead to overheating, smoking or burning.
When the baery gets hot, keep yourself and others a safe distance away from the baery. In case of damage or heat, you should
avoid touching the baery.
Do not disassemble the baery.
The baery contains protective components to avoid danger. Incorrect handling, such as improper disassembly, can destroy the
protective functions and lead to overheating, smoke and explosion.
Do not intentionally short-circuit the baery. Never allow the plus and minus connectors to come into contact with each other.
Do not allow the baery to come into contact with metal objects. It is dangerous if the baery is short-circuited. As it can lead to
overheating, smoke, explosion or burning.
Do not heat or burn the baery. An overheated or ignited baery can cause baery cells to explode.
Only perform operations described in this manual. Do not modify the electrical system/baery. No modules may be disassembled
or opened. Replace defective or worn-out baery components exclusively with the manufacturer’s original or approved spare
parts. Otherwise, any manufacturer guarantees and/or warranties will be voided. If non-original or incorrect spare parts are used,
the electric may not function correctly. Improper operation of the drive system and changes made to the motor may result in
injury or costly damage. In such cases, the manufacturer declines any liability for the damage caused. In addition, changes to the
baery or to the electrical system may result in criminal prosecution. For example, if the changes performed to cause the motor to
reach speeds above 25 km/h.
Modern Electric technology is high-tech. Working with it requires expert knowledge, experience, and specialized tools. Do not
perform any work on your Electric without approval from Velorei. Contact customer care. The electrical system includes the
following components: display, baery, drive unit, charger, sensors & controllers.
*Note: Content in the label is important information about this product. Please do not remove the information from the motor.
• Risk of re or explosion if baery is used with an incompatible system.
• Do not open, disassemble or pierce the baery due to a short circuit, re or explosion risk.
• In case of a drop, shock or similar event, do not continue to use the baery and return immediately for an examination.
• Only use the original charger as supplied with baery due to the risk of re or explosion.
• Disposal of used baeries should follow locally enforced regulations.
• Please carefully read the manual before use.