EasyManua.ls Logo

Veloretti Ace Two - Page 31

Veloretti Ace Two
130 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
EN
4. Get to Know Your Bike
Baery storage
Baery transport
Baery wear
Baery range
Do not use the baery near heat sources.
Do not use the baery near an open ame or at temperatures above 60 °C. High temperatures can cause the baery to burn or
explode.
Do not charge the baery near open re or in direct sunlight. This can cause errors or internal problems inside the baery, also
damaging the protective function. It can lead to abnormal chemical reactions or malfunctions that lead to overheating, smoke and
explosion.
Do not drop or damage the baery. This can lead to overheating, smoke and explosion. Never submerge the baery in water.
Do not charge the baery directly from the socket or a cigaree lighter in the car. High voltage and excessive current will damage
the baery and reduce its lifespan. It can lead to overheating, smoke and explosion.
Do not continue to use the baery if you notice that it gets hot during operation, charging or storage, develops a strong smell,
changes its appearance, or is otherwise unusual.
If you do not use your Electric for a long time, remove the baery, and charge about (60-80%) on. Store the baery separately in a
suitable dry place.
Remove the baery of your electric before transportation and transport it separately. When using a transport company to trans-
port your Electric, always discuss transport possibilities. Electric bikes and it’s baeries have specic transportation instructions
and specic insurances can be needed. Never send the baery yourself. Baeries are considered hazardous materials. In some
circumstances, it can overheat and catch re. Discuss possibilities with your transport company or Velorei customer care.
Natural wear and tear due to normal use and aging does not fall within the scope of our quality warranty. The baery capacity
decreases over time, thus reducing the range of the Electric. If baery’s capacity range is not enough, it may need to be replaced.
It is best to charge the baery at room temperatures and insert the baery just before the start of the journey. The discharge
cycle of the baery can be aected by: Used pedal power, Shiing seings, total weight (load and driver), tire air pressure, head-
wind, ambient temperature, road/underground condition, selected speed level, slope, Baery charge level, baery age, remaining
capacity of the baery.
Avoid direct sunlight from the sun, as it may cause it to overhead, and cause internal problems in the baery. It can lead to
abnor- mal chemical reactions or malfunctions that lead to overheating, smoke and explosion.
To prevent a deep discharge, the baery is put into sleep mode aer a certain time.
Do not extend the baery to temperatures below the permissible storage temperature of -10 °C to 35 °C. Note that tempera-
tures of about 45 °C are common near heaters, in direct sunlight or in overheated vehicle interiors.
By car
By train
You can transport your electric by car as you would a normal bicycle. Before transporting your electric, remove the baery and
transport it separately. The weight of the electric will call for a heavier-duty rack. Always adjust your driving behaviour to the load
you are carrying on the rack.
You can transport your electric by car as you would a normal bicycle. Before transporting your electric, remove the baery and
transport it separately. The weight of the electric will call for a heavier-duty rack. Always adjust your driving behaviour to the load
you are carrying on the rack.

Table of Contents

Related product manuals