Veloretti Ace Two - Page 33

32
EN
4. Get to Know Your Bike
Charging
Charging safety instructions
Use only the original baery charger supplied to you, as there is a risk of re or explosion if the incorrect charger is used.
You can charge your baery when mounted on the bike or when it is removed.
Plug-in your charger rst and then connect via the power socket.
Lithium-ion baeries are not subject to any memory eect. You can recharge your baery at any time, even aer short journeys.
Charge the baery at temperatures between 0°C and 45°C (ideally at room temperature approx. 20 °C). Give your baery enough
time to reach this temperature before charging.
The charging time depends on several factors. It can vary greatly depending on the temperature, age, use and capacity of the
baery. When the baery is fully charged, the charging process stops automatically. Unplug the connector from the baery and
then removed from the mains.
To prevent the risk of electric shock, you should never open the charger. Maintenance work may only be carried out by qualied
service personnel. Be sure to read the information about your charger before use! Unplug the power plug before connecting the
baery to the charger or removing it from the charger.
Keep the charger away from children and animals. In the event of malfunction or damage, it may result in a re or electric shock.
There is a light diode and buon on the baery. The diode will light up if you push on this buon. The diode will light up in various
colors. If the diode lights up in green the baery is fully charged. If the LED lights up red, you should charge the baery before your
next ride. The charge state of the baery will also be shown on the display.
LED charging state display
• The charger must not be operated by children or people with limited sensory or mental disabilities.
• Do not use your charger if it is moist or dusty. Avoid direct sunlight.
• Disconnect the charger from the power supply when not in use.
• Use only the original charger that came with your Electric.
• Do not cover the charger while in use. There is the possibility of short circuits or res.
• When cleaning the charger, unplug it from the power outlet rst.
• Stop the Charge process if the charging cycle lasts longer than the length listed in the Specications table.
Charging the baery
See chapter 3.01 Baery charging for explained steps.