Verathon GlideScope Core - Procedure 2. Use a USB Pulse Oximeter

35
Operations & Maintenance Manual: Using the Device
0900‑5017‑ETEE REV‑05
PROcEDURE 2. USE A USB PULSE OXIMETER
The SpO
2
values displayed on the monitor can be used as a convenient secondary display. These are not
intended for patient diagnosis. For direction on using the USB pulse oximeter, please refer to the Nonin
instructions for use.
IMPORTANT
The GlideScope Core monitor is compatible with the Nonin 3231 USB External Pulse Oximeter. When
connected, the SpO
2
and pulse rate can be found in the upper left corner of the display.
2018-10-14
95 min
A
B
A
B
98
% SpO
2
78
CITY HOSPITAL
10:55
A
B
0:27
6:16 AM2016-01-06
1:44 PM
10:29 AM
2017-03-15
2017-05-22
95 min
10:55 AM
2017-06-05
USBUSB Drive
Internal
Storage
60%
15%
CITY HOSPITAL
1. On the back panel of the monitor, remove the rubber cover from the USB and HDMI connector panel.
Connector panel cover
2. Connect the USB pulse oximeter to the one of the USB ports.
USB ports
3. When connected, the display shows a USB icon to indicate the device is attached.
4. Place the Nonin 3231 USB External Pulse Oximeter according to the manufacturer’s instruction. Once
placed, the SpO
2
information from the device appears on the screen.