EasyManua.ls Logo

Verderflex Ds500+ - Technical Specifications; Pump Specifications

Default Icon
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 | Page
Version 00
© Verder Liquids B.V
Ds500, Ds500+ Operating manual
Original instructions (en)
6. TechnicalSpecications
6.1 PumpSpecications
Detail Value
Supply voltage 100-240V50/60HzAC
Power consumption 250w
Dimensions(WxHxD) 216mmx246mmx210mm
Flow range 0.1 - 500ml/min*2
Max.dischargepressure 7 bar(g)
Max.suctionpressure 2 bar (g)*
1
Max.pumpspeed 65rpm
Max.temperatureof
pumped medium
70°C
Max.dischargespeed
adjustmentrange
5000:1
Seal sealing / protects
against system pressure /
full occlusion
Yes
(up to 60 PSI static,
100 PSI dynamic)
IP rating IP66, NEMA Type 4X
Noise level <70dB(A) @1m
Weight 8.25kg
Table 5. - Pumpspecications
*
1
Inletpressureshouldnotexceed2bar(g);increasedinlet
pressurewillresultinhigherowrate.
*
2
Maxowratebecomesdynamicifowcalibrationratiois
not default 1.000
6.2 Materials
6.2.1 Product contact (cartridge)
(in the event of cartridge / tube failure)
Detail Value
Tube Verderprene
Ports PP (Polypropylene)
Connectors PP
Seals EPDM (Ethylene Propylene
Diene Monomer)
Table 6. - Materials (product contact)
6.2.2 Non-product contact (pump)
Detail Value
Pump housing 20% GF PPE/PS (Polyphenyl
Ether + Polystyrene)
Stanyl
®
(rear panel)
Drive shaft P6 (nylon) (covering SS440C
shaft)
Cartridge 20% GF PPE/PS + PA6 +
Polypropylene
Screen enclosure 20% GF PPE/PS
Screen guard Polycarbonate
Keypad Polyester
Table 7. - Materials (non-product contact)
6.3 Chemical Compatibility
See https://www.verderex.com/leadmin/les/verderex/
documents/Verderflex_Chemical_Compatibility_Guide/
Verderex_Chemical_Compatibility_Guide.pdf
Operationunderanyotherconditionswouldrequire
approvalfromthemanufacturer,otherwisethismaya󰀨ect
the warranty.
6.4 Operating Conditions
6.4.1 Ambient
Detail Value
Operating temperature
range
4-45°C
Humidity 5-95%RH(non-condensing)
Max.altitude <2000m
Table 8. - Operating conditions
All units/calculations are based on operating conditions
below ≤ 2000m. For use above this height please check
with manufacturer or local representative for conrmation of
performance.

Table of Contents

Related product manuals