Verderflex Ds500+ - Operation; Pre-commissioning the Pump; Starting the Pump For the First Time

17 | Page
Version 00
© Verder Liquids B.V
Ds500, Ds500+ Operating manual
Original instructions (en)
9. Operation
9.1 Pre-commissioning the Pump
Making the pump ready for use. Ensure the following:
 Installation and connection is complete (Section 8.
Installation and Connection)
 Pipework is orientated correctly (discharge on top, inlet on
bottom)
 Cartridgettedandlockedinplace.
 Unit connected to mains outlet.
9.2 Starting the Pump For the First
Time
Whenthepumpisrstinstalled,orafterafactoryreset,theunit
willbootandrequesttheuserto:
1. Perform a screen calibration
2. Select a language
The pump will use the following (default) following parameters:
» Flow rate – 250ml/min
» Manual mode - On (Ds500+ only)
» Flowcalibrationo󰀨setratio–1.000
» AutoRestart–O󰀨
» FluidLevelMonitor–O󰀨
» Screen Lock - Disabled
» System PIN code - 1111 (also used for Factory Reset)
» Wi-Fi - Disabled
Press to start the pump.
9.3 Stopping the Pump
Press to stop the pump.
Moreinformationonscreencalibration,languageselection,parameteradjust,etc.canbefoundinSection10.NavigatingtheScreens.