1.2 Terminal structure1.1 Important
NOTE! If these instructions are not followed and the terminal is
damaged, the warranty will void!
• Protect the power cord and modem. If they are damaged, they are not to be used
anymore.
• The terminal is not waterproof or dustproof, and it is intended for indoor use only.
• If the terminal is exposed to water or dust, the warranty will void.
• Do not use the terminal next to water or moist areas.
• Do not use below 0°C degrees.
• Never place anything inside the chip slot or connection ports that is not meant
there. This might seriously damage the terminal.
• If the terminal is damaged, contact Point’s maintenance service. Never try to fix
the terminal by yourself.
• Use only appropriate paper with the terminal’s printer. Poor quality paper can jam
the printer and generate excessive paper dust.
• Never use thinner, trichloroethylene or ketone-based solvents – they may cause
deterioration of plastic or rubber parts. Do not spray cleaners or other solutions di-
rectly onto the keypad.
• Always shut down the terminal before removing the battery.
• Disconnecting the power during a transaction may cause transaction data files not
yet stored in the terminal’s memory to be lost.
• The terminals Li-ion battery is hazardous waste. Do not dispose of the battery with
combustible wastes. The battery should be recycled with other hazardous wastes
or delivered to the terminal supplier for disposal.
!
INTERNAL
THERMAL
PRINTER
SWIPE READER
F1-F4-KEYS
LILA1-4-KEYS
ENTER KEY
CLEAR KEY
CHIP CARD READER
PRINTER DOOR
LATCH
SERRATED
METAL STRIP
TERMINAL
DISPLAY
ALPHA-KEY
KEYPAD
CANCEL KEY
4 5
To Next Page
Loading...
Need help?
General
