Figure 2-2 Obliquity of the system
2.1.2 Unpacking
The cabinet uses a honeycomb cardboard and winding stretch film for packaging purposes. Shift the product to a
location closer to the final installation site prior to unpacking the unit.
Initially, remove the top cover and winding stretch film. Next, remove the honeycomb cardboard as depicted in Figure
2-3.
Figure 2-3 Unpacking the outer package
The unit is fixed on the packing pallet with M8*20 and M8*80 screws. Use a 17mm open-end spanner, ratchet
spanner, or sleeve to remove the screws.
Refer to Figure 2-4 to for the schematic diagram.
To Next Page