2.2 Equipment Inspection
When the unit is delivered, inspect all items for visible and concealed damage. Damage should be
immediately reported to the carrier and a damage claim filed with a copy sent to Liebert or to your sales
representative.
NOTICE
Risk of improper storage. Can cause equipment damage.
Keep the Liebert XDC upright, indoors and protected from dampness, freezing temperatures
and contact damage.
2.3 Equipment Handling
WARNING! Risk of unit falling over. Can cause injury or death.
The Liebert XDC is top-heavy. Use extreme caution when moving and installing this unit. Use
lifting equipment that is rated for the weight of the unit by an OSHA-certified rating
organization. See Table 11.1 on page127 for unit weights. Personnel should be properly trained
and certified to move and rig equipment
CAUTION: Risk of sharp edges, splinters and exposed fasteners. Can cause personal injury.
Only properly trained personnel wearing appropriate safety headgear, gloves, shoes and
glasses should attempt to move, lift, remove packaging from or prepare the unit for installation.
2.3.1 Handling the Liebert XDC While it is on Skid and Packaged
• Always keep the unit upright, indoors and protected from damage.
• If possible, transport the unit using a forklift truck. Otherwise use a crane with slings and
spreader cables. In either case, do NOT press on the top edges of the packaging.
• If using a forklift or pallet jack, make sure the forks (if adjustable) are spread to the widest
allowable distance to still fit under the skid.
• When moving the skidded unit with a forklift, do not lift the unit any higher than 3"(76mm). If
circumstances require the unit to be lifted higher than 3"(76mm), great care must be
exercised and all by-standing personnel are to be no closer than 20 feet (6m) from the lift point
of the unit.
NOTICE
Risk of structural interference. Can cause equipment or building damage.
While on the skid, the unit is too tall (83" [2108mm] overall height) to fit through a standard
doorway. Any attempt to move the unit, while skidded, through a standard doorway will cause
damage to the unit and to the building.
NOTICE
Risk of damage from forklift. Can cause unit damage.
Keep the forklift tines level and at a height suitable to fit below the skid and/or unit to prevent
exterior and/or underside damage.
Vertiv | Liebert® XDC™ User Manual | 10
To Next Page
Loading...
Need help?
General
