Vertiv Liebert XDC User Manual

3.2 Electrical Considerations
3.2.1 High Voltage Connections
Make sure the actual supply voltage and frequency correspond to the voltage and frequency indicated
on the Liebert XDC’s rating plate.
Connect cables for high voltage supply to the electrical box in the Liebert XDC according to Figure 3.1 on
page15, Figure 3.7 on page24 and Figure 3.8 on page25 and make sure that the phases are correctly
connected.
WARNING! Risk of electric shock. Can cause death and injury.
Disconnect all local and electric remote power supplies before working within.
WARNING! Risk of electrical shock, short circuit and/or control malfunction. Can cause
equipment damage injury and death.Damage to wiring or components can make unit unsafe to
operate.Use caution when installing wiring to prevent damage to factory wiring.Install
protective bushings in wiring knockouts as required to protect wiring from sharp edges.Do not
disturb factory wiring or route field-installed wiring over electrical terminals.Use NEC Class 1
wiring for all hazardous voltage electrical power supplies.Check and retighten all wiring
connections before starting the unit.
NOTE: Before beginning to install the Liebert XDC, read all instructions, verify that all the parts are
included and check the nameplate to be sure the Liebert XDC voltage matches available utility power.
Follow all local codes.
Vertiv | Liebert® XDC™ User Manual | 22

Vertiv Liebert XDC Specifications

General

Brand	Vertiv
Model	Liebert XDC
Category	Freezer
Language	English