Vertiv Liebert XDC User Manual

NOTICE
Risk of improper storage. Can cause unit damage.
Keep the Liebert XDC upright, indoors and protected from dampness, freezing temperatures
and contact damage.
NOTICE
Risk of overtightening securing straps. Can cause damage to panels.
Place a protective material between the straps of the piano jacks and the unit. Ensure that the
straps are not tightened to a point of damaging panels.
2.3.2 Unpacking the Liebert XDC
1. Remove the exterior stretch wrap packaging from the unit, exposing the protective corner and
side packaging planks.
2. Remove the corner and side packaging planks from the unit, exposing the bag over the unit.
The bag may remain in place for dust and panel protection or removed for immediate unit
installation.
3. Remove the bag from the unit when ready to remove the skid for installation.
Figure 2.2 Unpacking the Liebert XDC
2.3.3 Removing the Unit from the Skid Using a Forklift
1. Align the forklift with either the front or rear side of the unit.
Make sure the tines of the forklift are locked at their widest position.
Use the center of gravity indicators to determine the entry points for the tines. The tines must
be equally spaced on either side of the center of gravity indicator (see Figure 2.3 on the next
page).
Vertiv | Liebert® XDC™ User Manual | 11

Vertiv Liebert XDC Specifications

General

Brand	Vertiv
Model	Liebert XDC
Category	Freezer
Language	English