Vertiv Netsure User Manual

NetSure
™
Control Unit (NCU)
User Manual, UM1M830BNA
Spec. No: 1M830BNA, 1M830DNA Code: UM1M830BNA
Model No: M830B, M830D Revision M, May 12, 2017
[92]
IP Address: Sets the controller's IP address. Enter
the address in the format nnn.nnn.nnn.nnn, where
0 ≤ nnn ≤ 255. The address must be a valid address
and must not be 255.255.255.255.
Mask: Sets the controller's network netmask. Enter
the address in the format nnn.nnn.nnn.nnn, where
0 ≤ nnn ≤ 255.
Default Gateway: Sets the controller's gateway
address. Enter the address in the format
nnn.nnn.nnn.nnn,
where 0 ≤ nnn ≤ 255. This is the address of the
gateway of the network on which the controller
resides. The address must be a valid address and
must not be 255.255.255.255.
 Over Voltage 1: Sets the Over Voltage 1 alarm point.
 Over Voltage 2: Sets the Over Voltage 2 alarm point.
 Under Voltage 1: Sets the Under Voltage 1 alarm point.
 Under Voltage 2: Sets the Under Voltage 2 alarm point.
 Conv Volt Set: Sets the output voltage for all converters.

Vertiv Netsure Specifications

General

Brand	Vertiv
Series	Netsure
Humidity Range	5% to 95% non-condensing
Cooling Method	Forced air
Communication Interface	Ethernet
Protection Features	Overvoltage, overcurrent, short circuit, overtemperature