- The three 15 mm bearings must be fitted using
the appropriate tools.
Refitting the hub bearings
- Insert the cover prepared in the crankcase taking
care of inserting the gear of the pulley shaft on the
intermediary gear.
Refitting the ub cover
- Fit a new gasket together with the alignment
dowels.
- Fit the gearbox cover, making sure the breather
pipe is in the correct position.
- Tighten the 7 screws to the prescribed torque.
Locking torques (N*m)
Locking torque 24 to 27
Flywheel cover
Cooling hood
- Remove the fan cover cap acting on the 4 fixing screws.
CAUTION
DURING REMOVAL SLIDE THE CABLE GROMMET FROM THE HOUSING ON THE CAP.
Engine Vespa LX 125 - 150 i.e.
ENG - 108
To Next Page
Loading...
