Level check
Proceed as follows:
- Rest the vehicle on its centre stand with the han-
dlebars perfectly horizontal;
- Check the level of liquid with the related warning
light «A».
A certain lowering of the level is caused by wear
on the brake pads.
Top-up
Proceed as follows:
- Remove the front handlebar cover.
- Remove the reservoir cap by loosening the two
screws, remove the gasket and top-up using only
the fluid specified without exceeding the maximum
level.
CAUTION
ONLY USE DOT 4-CLASSIFIED BRAKE FLUID.
CAUTION
AVOID CONTACT OF THE BRAKE FLUID WITH YOUR
EYES, SKIN, AND CLOTHING. IN CASE OF ACCIDENTAL
CONTACT, WASH WITH WATER.
CAUTION
BRAKING CIRCUIT FLUID IS HIGHLY CORROSIVE; MAKE
SURE THAT IT DOES NOT COME INTO CONTACT WITH
THE PAINTWORK.
CAUTION
BRAKE FLUID IS HYGROSCOPIC; THAT IS, IT ABSORBS
MOISTURE FROM THE SURROUNDING AIR. IF THE CON-
TENT OF MOISTURE IN THE BRAKE FLUID EXCEEDS A
CERTAIN VALUE, BRAKING WILL BE INEFFICIENT.
NEVER USE BRAKE FLUID FROM OPEN OR PARTIALLY
USED CONTAINERS.
UNDER NORMAL CLIMATIC CONDITIONS, REPLACE FLU-
ID AS INDICATED IN THE SCHEDULED MAINTENANCE
TABLE.
N.B.
SEE THE BRAKING SYSTEM CHAPTER WITH REGARD TO
THE CHANGING OF BRAKE FLUID AND THE BLEEDING
OF AIR FROM THE CIRCUITS.
Recommended products
AGIP BRAKE 4 Brake fluid
FMVSS DOT 4 Synthetic fluid
Locking torques (N*m)
Maintenance Vespa LX 125 - 150 i.e.
MAIN - 42
To Next Page
Loading...
Need help?
General