Vespa LX Series User Manual

-Screw the nuts and lock them in a crossed sequence and in 2 or 3 stages to the specific torque.
Locking torques (N*m)
Locking torque 28 to 30
- Fit the two screws on the outside of the timing
chain side and tighten them to the specified torque.
N.B.
BEFORE INSTALLING THE HEAD, MAKE SURE THAT THE
LUBRICATION CHANNEL IS CLEAN USING A COM-
PRESSED AIR JET.
Locking torques (N*m)
Locking torque 11 to 13
- Fit the timing chain sprocket wheel on the crank-
shaft, with the chamfer facing the insertion side.
- Loop the timing chain around the sprocket on the
crankshaft.
- Fit the tensioner pad by the cylinder head.
- Fit the spacer and the screw fastener.
- Fit the pin, the outlet rocking lever, the spring
washer and the inlet rocking lever.
- Lubricate the 2 rocking levers through the holes
at the top.
- Lubricate the 2 bearings and insert the camshaft
in the cylinder head with the cams opposing the
rocking levers.
- Insert the retention plate and tighten the two
screws shown in the figure to the prescribed tor-
que.
Locking torques (N*m)
Locking torque 4 to 6
Engine Vespa LX 125 - 150 i.e.
ENG - 126

Vespa LX Series Specifications

General

Displacement	124 cc
Cooling System	Air-cooled
Front Tire	110/70 - 11"
Rear Tire	120/70 - 10"
Seat Height	785 mm
Kerb Weight	114 kg
Wheelbase	1, 280 mm
Length	1, 770 mm
Width	705 mm
Height	1, 140 mm
Engine Type	Single-cylinder, 4-stroke
Fuel System	Carburetor
Max Torque	10.4 Nm @ 6, 000 rpm
Transmission	Automatic
Front Suspension	Single-sided trailing arm with hydraulic shock absorber
Rear Suspension	Hydraulic shock absorber
Front Brake	200mm disc brake
Rear Brake	110mm drum brake