evenly. A 0.5 mm thickness difference in the re-
sidual friction material is permitted
Refitting
- Insert the brake pads
- Insert the fixing pin being careful to position the
clip with the ends towards the bleed screw as in
the photo.
- Insert the lock on the bolt and then the protection
cover
- Fix the brake calliper to the bracket and tighten
the two screws to the specified torque.
CAUTION
BEFORE USING THE BRAKE, OPERATE THE LEVER A
FEW TIMES.
Locking torques (N*m)
Rear brake calliper tightening screw 20 to 25 Nm
Fill
Braking system Vespa LX 125 - 150 i.e.
BRAK SYS - 210
To Next Page
Loading...
