EasyManua.ls Logo

Vespa LX Series - Page 79

Vespa LX Series
272 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FUSES
Specification Desc./Quantity
1 Fuses No. 4 - Current rating: 10 A Protected circuits: Battery-powered, lights remote con-
trol and antitheft-device pre-installation.
2 Fuses No. 3 - Current rating: 10 A Protected circuits: Live accessories, instrument panel,
horn, stop buttons and start-up remote control.
3 Fuses No. 5 - Current rating: 7.5A Protected circuits: Live, daylight running lights and
dashboard lighting.
4 Fuse No. 2 - Current rating: 7.5A Protected circuits: Live, coil, injection load remote con-
trol, immobilizer aerial and MIU.
5 Fuses No. 1 - Current rating: 20A Protected circuits: Vehicle main fuse.
6 Fuse No. 6 - Current rating: 15A Protected circuits: Battery-powered injection loads, in-
jection ECU and immobilizer LED.
Dashboard
A = Digital clock
B = Odometer
C = Speedometer
D = Engine control warning light
E = Engine oil pressure warning light
F = Turn indicators
G = High-beam warning light
H = Headlight warning light
I = Fuel gauge
L = Low fuel warning light
M = Immobilizer LED
Sealed battery
If the vehicle is provided with a sealed battery, the only maintenance required is checking its charge
and recharging, when necessary.
These operations should be carried out before delivering the vehicle, and on a six-month basis while
the vehicle is stored in open circuit.
Besides, upon pre-delivery it is therefore necessary to check the battery charge and recharge it, if
required, before storing the vehicle and, afterwards, every six months.
INSTRUCTIONS FOR THE RENEWAL RECHARGE AFTER OPEN-CIRCUIT STORAGE
1) Voltage check up
Before installing the battery on the vehicle, check the open circuit voltage with a standard tester.
- If voltage exceeds 12.60 V, the battery can be installed without any renewal recharge.
- If voltage is below 12.60 V, a renewal recharge is required as explained in 2).
2) Constant voltage battery charge mode
- Constant voltage charge equal to 14.40 to 14.70V
- Initial charge voltage equal to 0.3 to 0.5 for Nominal capacity
Vespa LX 125 - 150 i.e. Electrical system
ELE SYS - 79

Table of Contents

Related product manuals