64
Maintenance
Cone
Safety concerning maintenance work on the cutting unit
When working on the cutting unit the tractor must be stopped and
secured.
This prevents the machine from suddenly starting to rotate.
If the tractor and the PTO shaft have not been connected in
accordance the instructions, serious accidents causing damage to
limbs can occur.
When working on the cutterbar:
• The tractor engine must be stopped.
• The ignition key must be removed.
• The tractor's PTO must be disconnected.
• The tractor hydraulic system must be disconnected.
• The hand brake must be activated.
External inspection
Every day
»Maintenance intervals« page 53
An external check of the cone is carried out in the following way:
> Remove the pin.
> Open the guards around the machine's cutterbar.
> Carry out an external inspection of the cone on the right side of the
cutterbar for dirt.
> Clean the cone, if necessary.
To Next Page
Loading...
