Maintenance
102
It is important that the machine is correctly secured with a sturdy
support before work is started.
Locate the oilplug on the left-hand side of the cutterbar.
Remove the oilplug.
Let the oil flow into a suitable container.
Allow the last of the oil to drip out of the cutterbar for approx. 10 -
15 minutes.
Fit the oilplug and tighten it securely on the cutterbar.
Place the machine on a level surface.
Lower the cutterbar to the ground.
Check the position of the cutterbar with a spirit level and, if needed,
adjust its position with a wooden block.
!
To Next Page
Loading...
