Assembly - attachment
41
Pull out and release the lock for the guard.
Open the machine's front guard.
Block the cutterbar by placing a wooden block between the two
cutting discs.
Start the tractor and connect the tractor's PTO outlet.
Let the friction clutch rotate freely for approx. 5 seconds at the
lowest possible speed, until it is warm to the touch.
Do not allow the friction clutch to rotate for more than approx. 5
seconds at a time, as this may damage the friction discs.
Disconnect the PTO outlet and stop the tractor.
Remove the friction clutch from the machine.
To Next Page
Loading...
