18
The Vitocom 100 is operated solely by
SMS messages via a mobile phone.
Observe the following principles when
sending an SMS to the Vitocom 100:
■ The access code must always be at
the start of the SMS command.
■ Several SMS commands can be com-
bined into one SMS (except for
"reset" commands).
■ A space þ is always required between
the access code and one or more com-
mands.
■ The text length of an SMS command
is restricted to 70 characters. If the
text is longer it will be cut after the final
permitted character.
■ SMS commands may be composed in
upper or lower case.
Reply SMS
■ Every SMS received by the
Vitocom 100 is acknowledged with a
reply SMS.
– "OK": Command successful
– "ERROR": Command not carried
out (error)
■ The Vitocom 100 always sends the
reply SMS (acknowledgement) to both
mobile phone numbers "mobnr1" and
"mobnr2" (if programmed).
■ If the reply SMS is longer than 70 char-
acters, it is transmitted in several
replies.
Example SMS
3 commands combined in one SMS
1. Modification of the access code
■ accepted
2. Modification of mobile phone number
2
■ accepted
3. Modification of operating mode (0 =
DHW only) of heating circuit 4
■ Fault
(Only 3 heating circuits permitted)
SMS from the user
1111þcodeþ2345
þ
mobnr2
þ
017198765432
þ
bahk4
þ
0
Reply SMS as confirmation and error
message
2345 CODE 2345 OK MOBNR2
017198765432 OK BAHK4 0 ERROR
Controlling the device
SMS commands
5782 277 GB
To Next Page
Loading...
