20
Any pending messages from the heating
system, e.g. sensor or burner faults, are
sent to the Vitocom 100 via KM BUS.
The Vitocom 100 sends these messages
to the saved message destinations.
Note
In a LON system, only the control unit
that is connected to the Vitocom 100 via
the KM BUS is monitored.
Message content
■ Message type
■ Message code
■ Message text
For information on messages, see instal-
lation and service instructions for the
Vitotronic control units or the heat
source.
The following are automatically reported
by SMS via the mobile phone network:
■ Faults
■ Expiry of SIM card
■ If an expiry date for the SIM card
("enddat") was entered: Following a
power failure an SMS is sent request-
ing the current date "aktdat" to be
entered.
Example:
"aktdat" was deleted by a power failure.
After the power supply has been
restored, the Vitocom 100 sends the fol-
lowing SMS alert to "mobnr1" and
"mobnr2":
SMS alert as request:
1111þPlease enter AKTDAT
Control functions
Message forwarding
5782 277 GB
To Next Page
Loading...
