How to fix ViewSonic PJD5112 Projector with no power?
If your ViewSonic Projector has no power, several issues could be the cause. First, check the AC socket and its connection. If the fan fails after turning on, try reconnecting the fan or replacing the AC unit. Other solutions include replacing the power board, fan, Safety Switch board, keypad, checking the LED, keypad, and FFC, or checking the 7 pin Fuse.
What to do if ViewSonic Projector fail to light up?
If your ViewSonic Projector fails to light up, begin by checking the LED indicator and follow any indicative actions. If that doesn't resolve the issue, consider replacing the Lamp Module, power board, Ballast, Main board, or CW module.
What to do if ViewSonic PJD5112 Projector says 'Video No Signal'?
If your ViewSonic Projector shows 'Video No Signal', first ensure the source is turned on. If that doesn't work, try replacing the cable. As a last resort, the Main board might need replacement.
How to fix abnormal image on ViewSonic PJD5112?
If the image on your ViewSonic Projector is abnormal, try powering it on again and resetting the OSD. You can also adjust the input signal setting. If the issue persists, the Main board or Optical Engine may need to be replaced.
How to fix Remote Control Failure on ViewSonic PJD5112?
If the remote control for your ViewSonic Projector fails, first replace the battery. If that doesn't solve the problem, try replacing the remote control itself. If the issue continues, the IR or Main board might need to be replaced.
General| Projection distance | 1.2 - 10 m |
|---|---|
| Projection technology | DLP |
| Contrast ratio (typical) | 2000:1 |
| Projector native resolution | SVGA (800x600) |
| Aspect ratio | 4:3, 16:9 |
| RS-232 ports | 1 |
| Dimensions (WxDxH) | 280 x 218 x 114 mm |
| Power requirements | 90~240VAC |
| Lamp power | 180 W |
| Light source type | Lamp |
| Service life of light source | 3000 h |
| Service life of light source (economic mode) | 5000 h |
| Focus | Manual |
| RMS rated power | 2 W |
| Headphone outputs | 2 |
| Serial interface type | RS-232 |
| Noise level | 30 dB |
| Power consumption (standby) | 1 W |
| Power consumption (typical) | 235 W |
| Operating temperature (T-T) | 0 - 40 °C |
| Operating relative humidity (H-H) | 10 - 90 % |
| Product type | Standard throw projector |
| Market positioning | Presentation |
Weight and Dimensions| Weight | 2600 g |
|---|
To Next Page
