12
CDE Series
VGA
Custom
To select an input source:
1. Press INPUT/
on the remote control.
2. Press ▼/▲ on the remote control to select the PC source.
3. Press OK/ENTER on the remote control.
4. Press EPG/BACK/
on the remote control to exit.
NOTE: The above image is for reference only and is subject to change without
noce.
IFPG1 Series
To select an input source:
1. Press INPUT/
on the front panel.
2. In the OSD Menu, touch INPUT.
3. Touch the PC input source directly.
4. Touch a blank area outside of the menu to exit.
NOTE: The above image is for reference only and is subject to change without
noce.
To Next Page
Loading...
Need help?
General
