ViewSonic VPC-A31-O1 - Display Group Settings

77
Display Group Sengs
To adjust the Display Group Sengs, select the Display Group icon ( ) located in
the lower-right corner of the screen.
1. Toggle the “Turn On/O Display Group” ON to enable the Display Group feature.
NOTE: Other preinstalled ViewBoard Cast devices in the same network will be
listed.
2. Select the devices you want to join the display group and select OK to save the
sengs.
NOTE:
• If the devices you want to group are not listed, you can enter their
respecve IP address or connecng PIN code.
• The Display Group maximum device limit is six devices.